What's in the box
- 4 × Wheel Cover Discs
- 4 × Centre Lock Assembly (Screw + Adaptor + Centre Lock)
- 1 × Hexagonal wrench
- 1 x Flat Head Screwdriver
- Installation instruction or video ready (this page)
Before you start
- Park on a flat, stable surface
- Ensure the wheel rims are cool to touch
- Clean the wheel hub area before fitting
Step 1
Remove the original wheel hub cap. This can be done using the provided flat screw driver and prying it out from the wheel rim.
Hot Tip : Try inserting the flat screw driver tip as much as you can into one side of the hub cover, then gently tilt it so that the tip of the screw driver lifts the cap out of the hole.
Step 2
Rotate the wheel cover screw such that it levels with the entire bracket as shown in the picture. This ensures that the assembly can be inserted into the rim easily. Position the bracket at an angle, and push it firmly into the hole. The bracket should fit nice and snug with the wheel rim.
Hot Tip: There are typically 2 ways to insert the locking bracket. See video for demonstration.
1) Tilted at an angle, slowly, firmly push it into the wheel centre hole.
2) Perpendicular to the hole, position it nicely and knock the bracket directly into the hole.
Step 3
While holding on to the cover screw head, give it a few strong pulls to ensure that the locking mechanism is fully inserted into the wheel rim. This is very important as a wrongly placed bracket might lead to the wheel cover dropping off while the car is in motion.
After checking the fitment, you may remove the screw and the adaptor, to position the cover in the next step.
Step 4
The wheel cover adaptor helps to securely fit the cover to the locking bracket. Notice how the wheel cover fits into the groove of the adaptor, as well as how the adaptor fits to the grooves on the locking bracket. Carefully position them together nicely and the cover should sit nicely against the wheel rim.
Hot Tip: If you have a preference on how the cover is angled/appear on the wheel rim, this is the time to rotate the whole assembly. See video for more details.
Step 5
As the wheel cover is held in place, insert the cover screw into locking bracket. Screw it in enough so that the cover can be held in place without support.
Step 6
Lastly, use the provided hexagonal wrench to tighten the screw. There is no need to over tighten the screw, just ensure that the screw cannot be turned anymore with general arm strength.
🔧 Removing the wheel cover
Use the hexagonal wrench to loosen and unscrew the centre lock.
The wheel cover easily lifts off the centre bracket after removing the hexagonal screw.
The centre lock is reusable, there is no need to remove it.
Note: Always remove the wheel cover before accessing wheel bolts for servicing / tyre inflation.